When using an Industrial decanter centrifuge, the centrifuge tube and its contents must be precisely balanced on the balance beforehand. The difference in weight should not exceed the range specified in the respective centrifuge instructions. Each centrifuge has its own rotor. The allowable difference, the singular tube cannot be loaded in the rotor. When the rotor is only partially loaded, the tubes must be placed symmetrically in the rotor so that the load is evenly distributed around the rotor.
The industrial decanter centrifuge should not leave at random during the centrifugation process. The instrument on the centrifuge should be observed at any time for normal operation. If there is abnormal sound, stop it immediately and remove the fault in time. Each rotor has its own higher allowable speed and usage limit. When using the rotor, please consult the manual and do not use it too fast. Each turn must have a use file to record the accumulated use time. If it exceeds the higher use limit of the turn, it must be used at a reduced speed.
When loading the solution, it should be carried out according to the specific operation instructions of the industrial decanter centrifuge. According to the nature and volume of the liquid to be centrifuged, select the appropriate centrifuge tube. Some centrifuge tubes have no cover and the liquid should not be packed too much. After each use, the rotor must be carefully inspected, cleaned and dried in time. The rotor is the key component of the centrifuge that must be protected. When handling, be careful not to collide and avoid causing scars. Apply a layer of glazing protection. Never use a centrifuge tube that is significantly deformed, damaged or aged.